This is an adapted triangle-ruler for visually impaired students.
This model was designed and tested as part of the 3D4VIP project.
Menu
This is an adapted triangle-ruler for visually impaired students.
This model was designed and tested as part of the 3D4VIP project.
Designed by Thomas Batha, created with Sharp3D
Notes on monochrome 3D printing:
• PLA or ABS filament
• Print upright (on the hypotenuse) (post-processing with a file/sandpaper may be necessary
• or print horizontally (thorough post-processing with a cutter knife + key file (square), + sandpaper 150 + steel wool 000 is absolutely necessary in this case!)
• Layer Height: 0.15mm or less
• Wall Thickness: 0.8mm
• Infill Density: 30%
• Build Plate Adhesion Type: NONE
Notes on two-tone 3D printing:
• Print horizontally (thorough post-processing with a cutter knife + key file (square), + sandpaper 150 + steel wool 000 is absolutely necessary in this case!)
Part1-Body: Filament 1 (dark)
Position (lying):
X axis: 0
Y axis: 0
Z axis: 0
Part2 scales: Filament 2 (bright)
Position (lying):
X axis: 0
Y axis: 3.64
Z axis: 0
tactiles.eu has been produced by the 3D4VIP project co-funded by the Erasmus+ programme of the European Union
