A Saw guide made for a hand saw. This aid can be used on wood beams or plates <20 mm. Use a vice to cut panels under 20 mm thickness.
A Saw guide made for a hand saw. This aid can be used on wood beams or plates <20 mm. Use a vice to cut panels under 20 mm thickness.
A layer height of around 0.2 gives adequate results. Use a high infill number =>60% for optimal strength. There is no support needed for this model; a brim is recommended.
Note: the 45-degree angle might have a sharp edge after printing. Trim or sand the edge to ensure safety precautions.
tactiles.eu has been produced by the 3D4VIP project co-funded by the Erasmus+ programme of the European Union